Driver’s Side Power Window Switch Replacement – 2014 Kia Sorento

“This site contains affiliate links for which OEMDTC may be compensated”

2014-ELE069

 

SUBJECT:

DRIVER’S SIDE POWER WINDOW SWITCH REPLACEMENT

 

This bulletin provides the procedure to replace the window motor switch of some 2014MY Sorento (XMa) vehicles, produced from December 17, 2012 through December 13, 2013, which may exhibit an intermittent parasitic draw concern. Before conducting this repair, verify that TSB ELE057/SA163 – IPM Logic Improvement – has been performed on the vehicle. This procedure applies ONLY to vehicles equipped with Integrated Memory System (IMS) Seats.

 

Master Power Window Switch

 

*CAUTION 

Use a non-marring trim removal tool (Such as Snap-on Part Number PBN5 or equivalent) to avoid breaking tabs and/or damaging trim pieces.

 

Service Procedure:

  1. Turn the ignition to the “OFF” position and open the driver’s side door.

driver’s side door

 

*NOTICE

Verify the vehicle is equipped with an IMS switch.

IMS switch

 

  1. Remove the quadrant inner cover using  a non-marring plastic remover.   

quadrant inner cover

 

CAUTION

Exercise caution when removing the quadrant inner cover as it can be easily damaged.      

 

  1. Depress the lock pin to disconnect the  speaker connector.

speaker connector

 

  1. Remove the door grip handle cover  using a non-marring plastic remover.

door grip handle cover

 

  1. Remove the screw securing the upper  portion of the door grip.

screw securing the upper portion of the door grip

 

  1. Remove the screw securing the lower portion of the door grip.

Remove the screw securing the lower portion of the door grip

 

  1. Remove cover from inside door handle trim area and remove the screw.

cover from inside door handle

 

  1. Remove cap from outermost door panel mounting location and remove the screw.

cap from outermost door panel

 

  1. Remove trim cover and cap from inside the door handle pocket and remove the screw.

trim cover and cap from inside the door handle pocket

 

  1. Remove cap from innermost door panel mounting location and remove the screw.

cap from innermost door panel

 

  1. Use a non-marring plastic remover to dislodge bottom edge of the door panel.

dislodge bottom edge of the door panel

 

  1. Gently remove the door panel. Note: Make sure to disconnect all connectors from behind the door panel, prior to removal.

door panel

 

  1. Remove the screws securing the power window switch.

power window switch

 

  1. Install the replacement window switch, and all other removed components, by reversing the order of removal.

 

AFFECTED VEHICLE PRODUCTION RANGE:

Model Production Date Range
Sorento (XMa) From December 17, 2012 through December 13, 2013

 

REQUIRED PARTS:

Part Name Part Number Qty. Remarks
Window Switch 93570-1U201VA 1  

Color coded parts

(one per vehicle)

93570-1U201UP
93570-1U201H9
93570-1U201BB8

 

Loader Loading...
EAD Logo Taking too long?

Reload Reload document
| Open Open in new tab

Download [826.84 KB]

 

 

Leave a Comment

Share to...